All Voice of China 3D Printing

标题: Dazzle SG03 3d Uv Liquid Photosensitive Polymer Resin Dental Surgical Guide Resin For Implant [打印本页]

作者: Dazzle 时间: 2024-8-21 18:06
标题: Dazzle SG03 3d Uv Liquid Photosensitive Polymer Resin Dental Surgical Guide Resin For Implant
本帖最后由 Dazzle 于 2024-8-21 18:11 编辑

SG03 Description
DAZZLE SG03 is a solvent-free, high-viscosity, high-precision light-curing 3D printing photosensitive resin suitable for printing LCD surgical guides.

Product Name	SG03
Feature	Biocompatible
Application Field	Surgery Guide
Color	Transparent Yellow
Viscosity （25℃，cP）	1600-2000
Specific Gravity(g/cm3	1.07-1.12
Tensile Strength at Break(MPa)	44-55
Elongation at Failure(%)	5-10
Glass Transition (Tg,℃）	150
Shore Hardness	85D

DAZZLE SG03 is a solvent-free, high-viscosity, high-precision light-curing 3D printing photosensitive resin suitable for printing LCD surgical guides.Biocompatible and Transparent YellowIt can be formed within a few seconds under the irradiation of wavelength 355nm-405nm.The formula of this photosensitive resin mixture has been optimized to effectively inhibit beam penetration and avoid deep solidification. The minimum layer thickness for a single exposure can be controlled at 0.025mm, and the molding accuracy is high;
The curing speed is fast, and it can be cured quickly with low exposure. After molding, the appearance of the product is smooth and translucent, and it has high strength and high temperature resistance.
Fast curing, good biocompatibility, no irritating odor, and low irritation. This product is specially developed for surgical guides and has high strength, wear resistance and heat resistance (150℃).

Inhalation:
In case of exposure to a high concentration of vapor or mist, remove person to fresh air. Seek
medical attention immediately.
Eye Contact:
Immediately flush with plenty of clean water (under eye lids) for at least 20
minutes. Hold eyelids apart to ensure flushing. Washing within one minute of contact is
essential to achieve maximum effectiveness. Seek medical attention immediately.
Skin Contact:
Remove contaminated clothing and rinse contact area thoroughly with soap and water. Particular
attention should be paid to hair, nose, and ears, and other areas not easily cleaned. Wash clothing
before reuse.

Emergency Overview:
This product is a yellow colored liquid with a characteristic odor. This product may cause skin and
eye irritation.

For more information, please visit: http://www.dazz-3d.com/
Contact:
Email: dazz@dazz-3d.com
Phone: +86 18520814727

欢迎光临 All Voice of China 3D Printing (https://panda3dp.com/)